Hi all, I am at the stage now where I am about to put on my main blades, my question is that the nut that go's onto the main blade bolt is a nylock nut. Do I still put a little locktit on the bolt or will the locktit damage the nylock nut?
I know that any bolt that go's into metal should be locktited (thanks pgk), but not sure about nylock nuts.
Thanks in advance.
_________________
Jay
Trex 450SE V2, HS65MG Servos, Futaba GY401, DX6i TX, AR6200 RX.
450SE V2 Main Blades.
| Author | Message | ||||
|---|---|---|---|---|---|
|
jay7792 Senior Pilot   Age: 30 Joined: 26 Oct 2008 Posts: 194 Country of choice:  Location: Faversham, South East Coast |
|
||||
| Profile Private Message | |||||
| Board Alert | Board Message |
|---|---|
|
There are 9 posts in this topic to view if you are logged in.Why Register?
|
Similar Topics
| Topic | Last Poster | Forum | Replies | Posted |
|---|---|---|---|---|
| main shaft | nukiebroon | Honeybee (fixed pitch) modifications | 0 | Tue Jan 06, 2009 9:55 pm  |
| Free Play On Main Rotor Shaft | Dusty1000 | Walkera 4#3 | 1 | Tue Jan 06, 2009 8:07 pm |
| main blades rotation problems | acw995 | Belt CP | 6 | Mon Jan 05, 2009 9:19 pm |
| 4G3 wooden blades | Dusty1000 | Walkera 4#3 | 2 | Mon Jan 05, 2009 4:53 pm |
| wich way should i track my blades ? | DumbDawg | HoneyBee King (Collective Pitch) | 9 | Sun Jan 04, 2009 10:59 pm |
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
