I was flying last week when I had an obvious mechanical failure during flight. I was flying fwd and for no readon the heli started to roll and loose height. After lots of stik inputs and no reaction the heli hit hte ground... After a quick look the flybar case has snapped but more interestingly the control rod ball joint was off. (the oval shaped one, lower ball joint.) I thought this was more than likely due to the crash so I pospped it back on with ease... After applying very little pressure, it popped back off, the other one was also very loose. I have had about 30 batts through it and was wondering if this is common. I m still learning so have only done very basic flight, a couple of fig 8s and circuits. Is there anything else that I shoud check before I repair and then take to the air agan???
Cheers
Are loose ball links typical on a belt CP??
| Author | Message | ||||
|---|---|---|---|---|---|
|
Backrowslea New Pilot  Joined: 08 Jul 2008 Posts: 24 |
|
||||
| Profile Private Message | |||||
| Board Alert | Board Message |
|---|---|
|
There are 6 posts in this topic to view if you are logged in.Why Register?
|
Similar Topics
| Topic | Last Poster | Forum | Replies | Posted |
|---|---|---|---|---|
| Does the HB FP have adjustable servo ... | Hallsy | HoneyBee (Fixed Pitch) | 6 | Tue Nov 18, 2008 8:34 am  |
| belt-cp pitching forward | lankey | Belt CP | 16 | Mon Nov 17, 2008 2:54 am |
| belt bearing shaft info please | chopperaddict | Belt CP | 6 | Sun Nov 16, 2008 4:24 pm |
| How stable can the Belt CP be? | chopperaddict | Belt CP | 11 | Sun Nov 16, 2008 1:13 pm |
| Belt CP main rotor tracking changes r... | lankey | Belt CP | 12 | Sat Nov 15, 2008 11:35 am |
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
