C) Calibrating (learning) the transmitter neutral points
• Set the transmitter sticks to neutral, collective pitch to minimum, trims to
neutral, or - if you have already test-fl own the helicopter using the
HeliCommand and only small trim values are set - leave the trims where set.
• Hold the SET button pressed in for one second until the LED glows green,
then release it again and switch off. Job done. (If the LED becomes red: p.
Newer Version
C) Calibrating (learning) the transmitter neutral points
• Set the transmitter sticks to neutral, collective pitch to minimum, trims to
neutral, or - if you have already test-fl own the helicopter using the
HeliCommand and only small trim values are set - leave the trims where set.
• Hold the SET button pressed for one second until the LED glows green, then
release again - Job done. (If the LED does not become green: p.
Which is which, on the newer version if I remember correctly it will flicker red 10 times then go solid green. On the older one it just goes solid green and this is the one that you need to power down and up again for the set button to have an effect.
I have seen some place, but can't now find, that you can tell them by the serial number but that only comes up in the software - or maybe its on the package. If you can find the number a quick email to Captron in Germany will give you the answer.
I don't think it matters which mode, orange or green.
Graham
_________________
TRex 600E
TRex 450 V2
TRex 450 S - Hughes 500 + 5 blade head
TRex 450 V2 - Agusta A109 + 4 blade head (work in progress)
HBK2, HBK1, Lama IV, 3 x Piccalo Z's for the grandkids. JRDX9
