I changed my servos on the Belt CP, is this the correct way to set up the tail, ?
plug the tail servo and bypass the gyro, put the horn on 90 degrees (or close enough) to the boom, then attach servo via gyro and then set up the servo position on the boom by sliding it to get the right spot
If i don;t do this i don't know where the centre is of the servo in head lock mode (telebee gyro)
- trim is in the middle
belt cp gyro + servo setup
| Author | Message | ||||
|---|---|---|---|---|---|
|
o0dekker0o Senior Pilot  Joined: 20 Feb 2007 Posts: 233 |
|
||||
| Profile Private Message | |||||
| Board Alert | Board Message |
|---|---|
|
There are 2 posts in this topic to view if you are logged in.Why Register?
|
Similar Topics
| Topic | Last Poster | Forum | Replies | Posted |
|---|---|---|---|---|
| Esky Belt CP Super Kit for sale | darthdecon | Special Requests | 0 | Mon Sep 08, 2008 4:42 am  |
| pitch setup idle up | Trooper | Trex 450 XL and SE. Electronics, radios, set up, resources and discussion. | 1 | Sun Sep 07, 2008 11:56 pm |
| Tx Servo Switch | wicho001 | HoneyBee King (Collective Pitch) | 0 | Sun Sep 07, 2008 11:28 pm |
| Building my own belt-cp? | lamppis | Belt CP | 2 | Sun Sep 07, 2008 9:38 pm |
| ESC Setup? | Cougar | HoneyBee King (Collective Pitch) | 5 | Sun Sep 07, 2008 9:36 pm |
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
