I just got my CP2 new out of the box, and the darn thing will not calibrate correctly. The Receiver Red LED blinks twice and stays lit.
Per the manual, I have the throttle and trim down, but when the Battery is plugged in, there is an odd humming sound. If I move the throttle trim up one notch, the humming/buzzing goes away. (this is another issue)
After messing around a bit, the only way I could get it to calibrate / Green LED was to hold up on the Elevator stick. Very odd.
Does anyone have any ideas what the problem might be?
I have tried every combination of servo reverser switches as well, but nothing seems to work. Is it possible the servos are not aligned correctly?
Thanks
-kev
Brand New CP2 won't calibrate
| Author | Message | ||||
|---|---|---|---|---|---|
|
imthemiz New Pilot  Joined: 08 Aug 2006 Posts: 3 |
|
||||
| Profile Private Message | |||||
| Board Alert | Board Message |
|---|---|
|
There are 14 posts in this topic to view if you are logged in.Why Register?
|
Similar Topics
| Topic | Last Poster | Forum | Replies | Posted |
|---|---|---|---|---|
| my gyro does not calibrate | Cougar | HoneyBee King (Collective Pitch) | 8 | Tue Jul 22, 2008 7:04 pm  |
| Brand new DX6i but which heli?? | Anti_A | Belt CP | 3 | Fri Jul 11, 2008 8:29 pm |
| EXCEED Brand Controller? | missyh | Other RC Helicopters | 0 | Sat Jun 07, 2008 1:47 pm |
| My Helli has a brand new coat! | jonnyb | Belt CP | 12 | Wed May 28, 2008 12:43 pm |
| Dodgy Spares (Not Align or Trex Brand) | crackerj | Trex 450 XL and SE. Electronics, radios, set up, resources and discussion. | 3 | Sat May 17, 2008 10:20 pm |
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
