Im up to the radio installation nearly. just want to check something out with the main rotor head assembly. This is installed and attached to the main gear with the single screw and nut at the bottom of the shaft. As i turn the rotor should this be very smooth and free? As i turn it i can feel a bit of resistance. You cant really spin it as the bottom gear, the auto-rotation tail drive gear seems to hinder it.
Thanks.
Building trex 450se v2
| Author | Message | ||||
|---|---|---|---|---|---|
|
bowkite Senior Pilot  Joined: 14 Aug 2008 Posts: 84 Country of choice:  |
|
||||
| Profile Private Message | |||||
| Board Alert | Board Message |
|---|---|
|
There are 65 posts in this topic to view if you are logged in.Why Register?
|
Similar Topics
| Topic | Last Poster | Forum | Replies | Posted |
|---|---|---|---|---|
| Trex 250 available | Skint Eastwood | T Rex 250 resources and discussion | 0 | Sat Nov 29, 2008 5:08 pm  |
| Trex 450 XL HDE | flossie | Trex 450 XL and SE. Electronics, radios, set up, resources and discussion. | 0 | Sat Nov 29, 2008 4:40 pm |
| Trex 500 servo and gyro | gregsblade | Trex 500, resources and discussion | 1 | Fri Nov 28, 2008 9:13 pm |
| any bulid advice or mods recomended f... | master65 | Trex 450 XL and SE. Electronics, radios, set up, resources and discussion. | 4 | Fri Nov 28, 2008 8:32 pm |
| Not a good week for me or my Trex | PokeDad | Trex 450 XL and SE. Electronics, radios, set up, resources and discussion. | 17 | Fri Nov 28, 2008 1:21 pm |
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
