Heliguy Forum - RC heli forum

hi guys,

been flying my new cx450 this week with the new gy401b and am fining I am not getting a good stop on the rudder input. the tails holds really well with punch outs and in the wind but when I piro then stop there is a few degrees of movement after letting go of the stick. I am assuming from the reviews I have seen that this must be one of a number of things I have done so here is the list . .

Servo: HXT500 dont have anything better just yet but it is holding fine in forward flight and against the wind and with punch outs so not sure why it would have a problem after any tail input.

Gyro position: this I am thinking of changing tonight as a test, I have the gyro almost directly under the main shaft and even slightly forward and all other gyros I have had have been set up at the back end of the frame, could this be a factor?

Delay and Limit settings: not touched them, I did dial down the delay pot whilst out today but did not notice any difference, any ideas what effect these will have or where I should set them given my servo?


Anything else . .please advise . .

Thanks again,
Tony.
_________________
CX450Pro Turnigy Typhoon 2215H, AR6100e, Futaba 401 / Turnigy DS480, 3x HS-65mg - a/w spares
CX450AE Turnigy E500, AR6200, D'Sky 401 / DS480, 3x HXT900 - a/w rebuild
HBK2 a/w rebuild
DX6i
Micro Mosquito - the only thing in one piece!