BELOW IS THE INFORMATION YOU REQUIRE TO SUCCESFULLY REWIRE YOUR SERVO`S TO THE ESKY RECIEVER.
Thanks to Maverick440 for the Picture.
This information is Here: http://www.heliguy.com/Forum/honeybee-king-servo-und-receiver-details-t1344.html But i will also post again for everyones benefit.
on reciever:
Channel 1 is to SERVO 3 (C)
Channel 2 is to SERVO 2 (A)
Channel 3 is to ESC/BATTERY
Channel 4 is to the GYRO - SERVO 4
Channel 6 is to SERVO 1 (B)
The WHITE wire goes to the top of the Reciever, Depending on which was you mount it.
The information you require is on Page 10 & 11 of your eSky King Manual.
Hope this helps.
_________________
Thanks, Paul
Futaba FF7 2.4Ghz
Trex 600NSP R617FS, OS50H, S9254 & Gy401, 3x 5625MG + 625MG
Boomerang 40 R606FS, SC46 Engine
Imax B5, Cellpro 4S
