Hi all,
after a certain time, the red LED of my stock TX of the lama v3 (2.4GhZ) does not twinkle
anymore after power up. It did very well at the beginning, then only after a long period
being switched off, and now not anymore. I can't sync anymore, though...
Any idea?
Could I eventually use my futaba 6ex 2.4Ghz TX with it? Any assume, they're not compatible.
Can I replace the receiver of the 4in1 module with the futaba one and use only gyro and esc
module? Did anyone do that already? Any 'datasheets' of which connector is what of the gyro/esc?
thanks
Matthias
Esky Lama v3 2.4Ghz TX problem
| Author | Message | ||||
|---|---|---|---|---|---|
|
ism New Pilot  Joined: 19 May 2008 Posts: 2 |
|
||||
| Profile Private Message | |||||
| Board Alert | Board Message |
|---|---|
|
There are 4 posts in this topic to view if you are logged in.Why Register?
|
Similar Topics
| Topic | Last Poster | Forum | Replies | Posted |
|---|---|---|---|---|
| Problem with my 600nsp build | kenny.c | Trex 600 Nitro, resources and discussion. | 0 | Fri Jul 25, 2008 12:24 pm  |
| Futaba t6exhp tx and esky reciever | lonewolf | Radio Receivers | 0 | Fri Jul 25, 2008 8:22 am |
| Futaba t6exhp tx and esky reciever | russell from brisbane | Radio Transmitters. | 1 | Thu Jul 24, 2008 9:57 pm |
| Which is better, Lama or CX2 | MelBrit | General RC helicopter Q&A's | 0 | Thu Jul 24, 2008 3:01 pm |
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
