Just installed 4 SG90 servos on the Belt and I have temporarily connected all leads to Spektrum 6200 RX so as to set up arms and swash etc. I say temporarily because it is hanging out of the side of the main frame so that the elevator servo lead will reach.
Where do you guys locate your receiver with these servos?
Is it safe to fix centrally, under the main body or do you extend the elevator servo lead and install rx in the usual position?
I am also awaiting a UBEC to take some load off of the stock ESC.
Any suggestions appreciated.
Fitting SG90 servos.....
| Author | Message | ||||
|---|---|---|---|---|---|
|
Dazzlercee New Pilot  Joined: 26 Dec 2007 Posts: 31 Country of choice:  Location: Stoke-on-Trent |
|
||||
| Profile Private Message | |||||
| Board Alert | Board Message |
|---|---|
|
There are 17 posts in this topic to view if you are logged in.Why Register?
|
Similar Topics
| Topic | Last Poster | Forum | Replies | Posted |
|---|---|---|---|---|
| what are the servos, and where do the... | pmdevlin | HoneyBee King (Collective Pitch) | 7 | Thu Nov 27, 2008 7:44 pm  |
| servos back wards after swapping out ... | Cougar | HoneyBee King (Collective Pitch) | 12 | Sat Nov 15, 2008 5:40 pm |
| HS-82MG servos and Trex 500 | Essexsaxo | Trex 500, resources and discussion | 14 | Wed Nov 12, 2008 4:46 pm |
| are there different type s of sg90 or... | Ironman | Servo's | 2 | Sat Nov 08, 2008 10:18 pm |
| Metal Gear Servos | sophie | Belt CP | 2 | Sat Nov 08, 2008 2:07 pm |
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
