fitting uprated blades....

Post new topic Post reply

Author

Message

Acky1980
New Pilot

Joined: 28 May 2008
Posts: 27

Posted: Sun Jun 22, 2008 7:40 pm
Post subject: fitting uprated blades....

Quote

hi everyone, thanks for all your advice on my recent posts. i'm looking at fitting some uprated main blades, i know you can get simple carbon blades for the belt cp (an others) but i was looking at putting some decent quality ones on instead. However the standard wooden blades have little plastic shims either side of the bolt hole, an the uprated versions dont have these. any ideas on suitable shims?? or some where i could source them from?? the blades im looking at fitting are Curtis Youngblood RADIX 3D 325mm precision blades

Profile Private Message

Board Alert	Board Message
	There are 4 posts in this topic to view if you are logged in. Why Register? Your details are kept secure and private. Heliguy.com will not share your details You can unsubscribe at any time PM Earlgrey for any forum queries. Login here and be redirected to this Topic Register

Board Alert

Board Message

There are 4 posts in this topic to view if you are logged in.

Why Register?

Your details are kept secure and private.
Heliguy.com will not share your details
You can unsubscribe at any time

PM Earlgrey for any forum queries.

Similar Topics

Topic	Last Poster	Forum	Replies	Posted
Copter X wooden blades don't fit	weblst	Copter-X Helicopters	1	Mon Oct 06, 2008 10:17 pm
Radix tail blades	lankey	Belt CP	3	Sat Oct 04, 2008 12:37 pm
Carbon tail blades	arichards1969	HoneyBee King (Collective Pitch)	15	Sat Oct 04, 2008 2:10 am
Which Belt CP blades?	Tristin	Belt CP	6	Fri Oct 03, 2008 1:11 pm
Removing Main Blades	ChickenHawk	HoneyBee (Fixed Pitch)	3	Thu Oct 02, 2008 11:20 am

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

Heliguy Forum - RC heli forum