Heliguy Forum - RC heli forum

Hooray, the inner shaft coming back in stock means I'm back in the air (well a few feet off the ground anyway)

I'd like to get some advice about how to tackle a problem I have the the heli contstantly rotating to the left, I've trimmed the control all the way to the right, but still have to constantly correct. I know I should expect to make little corrections, but this seems more than expected (I think) I figured I should at least be able to trim it to be vaguely still.

The only problem with this constant correction is that it's taking up too much of my concentration, so when flying out and then turning round to fly back towards me, I don't have enough concentration left to remember my left/right has been reversed !

I just had a good read through the 4-in-1 adjustment thread, as my tail is not waggling side to side, I don't think a gain adjustment is what I need.

I didn't know if this would be affected by the ball-link on the fly-bar linkage, but the thread didn't actually go into why you would ever change this.

In short I'm a tad confused about what I should be adjusting, so not wanting to experiment and screw it up, I thought I'd ask you guys.