I just recently finished the "Shizzle" mod, but on test flight the shaft on the motor snapped after one short hover. I replaced 4000kv Brushless with a 3400kv Turnigy. Set the tail on the turntable and took it outside for a flight. Powered up to 50% and started to get lift gave it a bit more and lift off followed by my first invert! from 6 inches off the deck. Fixed it up same again, over on to its back!!!!
It seems to have a glich it the servos big time. Replaced servos, still there, replaced RX, still there, tried mates radio, still there. after a couple of hours scratching heads I removed "Shizzle" mod, no more gliche. What the???????
My brackets for the mod where made of Aluminium alloy, not highly conductive, but enough to hit the right note at high RPM to stuff everything. You live and learn the hard way with this heli. I'll now try using some thing different for the brackets.
Anyone else come across this???? What materials do you use???
Cheers Al
_________________
____________________________________________
The only silly questions are the ones not asked!
__________
HBK 2 - 3400 Turnigy/10T, DX6i + AR6200, HXT900 cyclics, Stock Gyro + HXT500
