Had to get pinion off motor last night, and I couldn't find a suitable nut to use to make the removal tool shown in the forum, so after a bit of looking around I came up with this. Takes about 10 mins to make, less if you have a dremel. Basically just a U Bolt with a slot cut into unthreaded hoop, threads extended on screw in bolt and end of screw in bolt tapered down using file t allow it to pass through the hole in pinion.
Enjoy
regards
Radamlod
_________________
Walkera 5#10 stock
HBK2 with:
Esky 3100KV 10T & Esky 25A ESC
Extreme Motor mount/Stiffner
Extreme 43T pulley
2200 Mah Lipos
CNC Head 'n Tail
Futaba 7C Tx
Esky receiver








