I just installed Dynam 30 A on my heli and when I plug in the battery there is a sound and after that it bleeps 5 times (about 2 seconds between bleeps). If I put the a little throttle on, the motor starts spinning but then slowly dies. I have the Dynam programming card and set it to Cut of type: slowdown, Brake: off, Throttle curve: linear and Outrunner. When I put a little more throttle the motor works fine but the Esc got really hot and stared to smell a little. Can some one tell me what the problem could be? I am using a lipo battery and esky motor. I have been trying to get this heli in the air for a long time and all the time there is a new problem!! Just to check is it the middle wire from the esc that goes to the blue one on the motor? Please help!
_________________
Esky Belt CP, Futaba GY-401
TowerPro SG90 * 4, Dynam 30A ESC
Spectrum DX6i
Problem with Dynam 30A
| Author | Message | ||||
|---|---|---|---|---|---|
|
Robban Junior Pilot  Joined: 25 Jun 2008 Posts: 44 Country of choice:  Location: Helsinki |
|
||||
| Profile Private Message | |||||
| Board Alert | Board Message |
|---|---|
|
There are 29 posts in this topic to view if you are logged in.Why Register?
|
Similar Topics
| Topic | Last Poster | Forum | Replies | Posted |
|---|---|---|---|---|
| DX6i and GY401 Setup Problem | Wobbly Goblin | Gyros | 1 | Wed Oct 08, 2008 12:38 am  |
| 2.4 "Binding" problem? | Bugster | HoneyBee (Fixed Pitch) | 5 | Mon Oct 06, 2008 8:01 pm |
| Servo problem | Tristin | Belt CP | 10 | Sun Oct 05, 2008 4:37 pm |
| SKYA Gyro Setup Problem | ianward | Belt CP | 13 | Sun Oct 05, 2008 11:40 am |
| Newbie....with a problem | Earlgrey | Syma RC Helicopters | 3 | Thu Oct 02, 2008 5:53 pm |
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
