Search found 7 matches
| Author | Message |
|---|---|
| Topic: My Lama dips to the left! | |
| M55ikael Replies: 10 Views: 308 |
 Forum: Lama Posted: Thu Jun 26, 2008 3:43 pm Subject: My Lama dips to the left! |
| Hi! Thanks for the replies! I wrote Trim and gain adjusted when I really meant proportional and gain adjusted.
My problem really isn't the Lama spinning to the left. It always dips forward and to ... |
|
| Topic: My Lama dips to the left! | |
| M55ikael Replies: 10 Views: 308 |
Forum: Lama Posted: Wed Jun 25, 2008 11:35 pm Subject: My Lama dips to the left! |
| Basically what the topic says, it turns to the left no matter how much I trim it to the right (I could fix it with full trim before, now it's not sufficient anymore).
Ok checklist: Flybar level ... |
|
| Topic: Inner shaft won't connect at the bottom | |
| M55ikael Replies: 4 Views: 242 |
Forum: Lama Posted: Sun May 25, 2008 12:37 pm Subject: Inner shaft won't connect at the bottom |
| are you sure you bought the correct innershaft? because if the diameter and the length as the same as the stock it would be no problem at all...just push it to the outershaft from the top, put the gea ... | |
| Topic: Inner shaft won't connect at the bottom | |
| M55ikael Replies: 4 Views: 242 |
Forum: Lama Posted: Sat May 24, 2008 2:11 pm Subject: Inner shaft won't connect at the bottom |
| I can't get the inner shaft to stick far enough through to connect it properly at the bottom. What in the world migth be causing this? I recently bought an aftermarket inner shaft, but now I have the ... | |
| Topic: Contemplating Mods | |
| M55ikael Replies: 4 Views: 231 |
Forum: Lama Posted: Tue May 13, 2008 7:18 pm Subject: Contemplating Mods |
| I've now ordered:
Two complete sets of Xtreme blades A crash resistant tail A 2cm extended aluminum inner shaft And some stock spare parts Once I get the stuff I will probably grab my airbrush ... |
|
| Topic: Contemplating Mods | |
| M55ikael Replies: 4 Views: 231 |
Forum: Lama Posted: Tue May 13, 2008 12:22 pm Subject: Contemplating Mods |
| All I can say about the bearing housing to me is looks.
Ok! I'm going to steer clear of the bearing housing then. Greetings M55 ! 
As in my other post there is one thing I would stay awa ... |
|
| Topic: Contemplating Mods | |
| M55ikael Replies: 4 Views: 231 |
Forum: Lama Posted: Tue May 13, 2008 1:43 am Subject: Contemplating Mods |
| Hello everybody! I must say that you've got a really informative forum going on here.
I am going to buy some upgrades and someone mentionedthe heli-direct aluminum bearing housing as one of the ess ... |
|
