Hi all, I am back after what seems an eternity - had a big crash and had to leave it a while, anyway finally managed to order all the spares i needed (Pretty much the entire kit) and have rebuilt - decided this time i would add a HH Gyro and ordered the SKYA one on recommendation from Heliguy - when installing initially i misread the instructions where the base was meant to be perpendicular to the main shaft (Ie gyro flat sticker to top) and installed on its side bottom parallel to main shaft spun up and worked to a degree... so i decided to go back and look again at the instructions where i found i had mounted the gyro incorrectly - I now have it installed properly as below
However the tail now spins wildly out of control. What am i doing wrong?
The heli is standard other than upgrading to SG90's, still on original ESKY transmitter and training gear and cant wait to get back in the air, but cant seem to figure out why she spins out of control? - Please any idea's / advice on how to sort this would be greatly appreciated
Regards - Ian
_________________
Esky Belt CP | SG90s | SKYA HH Gyro | Futaba 6EXHP | Training Gear