Hi guys
I powered up my belt today to do part 4 of Anti A's guides (setting up the tail) and noticed that the pitch servo was making a weird noise. Turns out its going to full lock for no reason. On the Tx Idle Up is off, Pitch is set to 0, trims are all centered except throttle which is down. All sticks in middle except throttle which is down. Switches set to Down, Up, Down, Up
Tried powering it up with motor disconnected and it does the same thing. Is it interference or a problem with the Tx or Rx? or is it the servo?
Sounds like im going to have to strip it down and start again, see if its the servo or the rx by changing channels around.
Any ideas would be useful. First Heli and was just getting ready to start learning after getting it set up.
Pitch Servo Locking to Full Pitch
| Author | Message | ||||
|---|---|---|---|---|---|
|
Graeme508 New Pilot  Joined: 20 Apr 2008 Posts: 10 Country of choice:  |
|
||||
| Profile Private Message | |||||
| Board Alert | Board Message |
|---|---|
|
There are 5 posts in this topic to view if you are logged in.Why Register?
|
Similar Topics
| Topic | Last Poster | Forum | Replies | Posted |
|---|---|---|---|---|
| Gyro or Servo? | Derrell | HoneyBee King (Collective Pitch) | 6 | Fri Aug 08, 2008 1:53 pm  |
| Golden Eagle tail pitch yoke | Cpt_Tangerine | Other RC Helicopters | 0 | Fri Aug 08, 2008 7:36 am |
| belt cp gyro + servo setup | c5 | Servo's | 1 | Fri Aug 08, 2008 1:10 am |
| Rudder servo nor or rev? | Cougar | HoneyBee King (Collective Pitch) | 2 | Thu Aug 07, 2008 1:48 pm |
| Servo mounting screws | carpman | Trex 600 Nitro, resources and discussion. | 0 | Thu Aug 07, 2008 12:04 pm |
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
