Hi all,
after a certain time, the red LED of my stock TX of the lama v3 (2.4GhZ) does not twinkle
anymore after power up. It did very well at the beginning, then only after a long period
being switched off, and now not anymore. I can't sync anymore, though...
Any idea?
Could I eventually use my futaba 6ex 2.4Ghz TX with it? Any assume, they're not compatible.
Can I replace the receiver of the 4in1 module with the futaba one and use only gyro and esc
module? Did anyone do that already? Any 'datasheets' of which connector is what of the gyro/esc?
thanks
Matthias
Esky Lama v3 2.4Ghz TX problem
| Author | Message | ||||
|---|---|---|---|---|---|
|
ism New Pilot  Joined: 19 May 2008 Posts: 2 |
|
||||
| Profile Private Message | |||||
| Board Alert | Board Message |
|---|---|
|
There are 4 posts in this topic to view if you are logged in.Why Register?
|
Similar Topics
| Topic | Last Poster | Forum | Replies | Posted |
|---|---|---|---|---|
| Took off my GY401 and put the Esky hh... | chase_richard55 | HoneyBee King (Collective Pitch) | 5 | Fri Aug 29, 2008 9:35 pm  |
| Lama 4 in 1 Repairable ???? | Earlgrey | Lama | 3 | Thu Aug 28, 2008 10:17 pm |
| Honey Bee CP2 Flight Sim Problem | Earlgrey | Flight Simulators Q&A's | 3 | Thu Aug 28, 2008 7:50 pm |
| New King 2 now released on Esky offi... | timbo1472 | HoneyBee King (Collective Pitch) | 19 | Thu Aug 28, 2008 7:14 am |
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
