Hi Im from Holland and im new here.
I have a lama v3 and im loving it.
However I have one problem.
The innershaft wont come off. I need to replace the outershaft (the one that drives the bottom blades)
The wheel that drives the bottom blades got wear so i need a new one and i just cant get the old one uit.
This is what i did??
• REMOVE BATTERY HOLDER
• REMOVE THE TAIL.
• REMOVE THE CABIN (FRONT CLEAR PLASTIC COCKPIT)
• REMOVE LANDING GEAR (DO NOT REMOVE WIRE HARNESS FROM ANY OF THE SERVO OR MOTORS)
• REMOVE THE INNER SHAFT ALONG WITH INNER SHAFT HOLDING GEAR AT THE BOTTOM.
• REMOVE THE OUTER SHAFT BLADES AND ALL LINKS
• REMOVE THE OUTER SHAFT TOP BEARING (PULL IT OUT)
• REMOVE THE SWASHPLATE AND OTHER LINKS HOLDER ON TOP.
• REMOVE THE OUTERSHAFT RETAINING BEARING AT BOTTOM
• REMOVE THE OUTSHAFT HOLDING BEARING.
• REMOVE THE OUTERSHAFT COLLAR (LOCATED JUST BELOW THE SWASHPLATE)
• REMOVE THE SHAFT FROM UNDERNEATH (LANDING GEAR SIDE)
• NOW REMOVE THE BEARING FROM THE TOP THAT HOLDS THE OUTERSHAFT IN ITS CASE.
• THATS ALL....OUTERSHAFT IS OUT.
STIL IT WONT COME OUT.
Thanx
shaft B problem lama v3 please help!
| Author | Message | ||||
|---|---|---|---|---|---|
|
matsumatsu New Pilot   Joined: 06 Dec 2007 Posts: 20 |
|
||||
| Profile Private Message | |||||
| Board Alert | Board Message |
|---|---|
|
There are 6 posts in this topic to view if you are logged in.Why Register?
|
Similar Topics
| Topic | Last Poster | Forum | Replies | Posted |
|---|---|---|---|---|
| question about pinion and main shaft | oakcityfido | Belt CP | 3 | Fri Aug 29, 2008 6:42 pm  |
| Lama 4 in 1 Repairable ???? | Earlgrey | Lama | 3 | Thu Aug 28, 2008 10:17 pm |
| Honey Bee CP2 Flight Sim Problem | Earlgrey | Flight Simulators Q&A's | 3 | Thu Aug 28, 2008 7:50 pm |
| main shaft gear | Starbuckin | Lama | 1 | Thu Aug 28, 2008 6:50 pm |
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
