Heliguy Forum - RC heli forum

Hi. I've got some problems connecting my new Futaba 6EX 2.4GHz to my computer for simulator training. I've bought a USB interface cable for Futaba transmitters but there were no instructions with it. When I plugged it into my computer a driver was successfully installed , but I can't find anything under "game controllers" at the control panel (I've tried with both XP and Vista).

I found this info somewhere:

- Your Futaba must be in PPM Mode not PCM
- The trainer switch must be set but no need to go in trainer mode.
- Your controller must be ON.

My wonderings are:
I don't know weather the TX is in PPM or PCM and how do i "set" the trainer switch?

Any advice is really appreciated
_________________
//Ola

Honey Bee King 2 (3900 BL motor, 25A ESC + 11T pinion, E-sky HH gyro, Two E-sky 1800 mAh 20C Li-Po batteries and some silicon oil spray)