I am re posting this from the end of my other post in case people dont read all the way to the bottom of that one, hope thats ok??
I have set up the DX6i as per the settings given by funflier but I think I either missed something or am doing something wrong . .
So . . I just tried to set the pitch by increasing the links on the swash . . I failed. the pitch at low stick is -off the gauge and with the links extended right to the tips of the thread I am still no where near -2ยบ This is where I noticed the servo horns . .at low stick they are not level to the ground but rather at maybe 4 o'clock (rather than 3 o'clock) do I have some settings wrong or do I have to reset the center position of the servos? Thanks again,
Tony
The question may make more sense if you read the bottom few posts in this thread: here
DX6i question 3 of Many . . Pitch
| Author | Message | ||||
|---|---|---|---|---|---|
|
root729 Senior Pilot  Joined: 07 Feb 2008 Posts: 236 Country of choice:  Location: Gozo, Malta |
|
||||
| Profile Private Message E-mail | |||||
| Board Alert | Board Message |
|---|---|
|
There are 9 posts in this topic to view if you are logged in.Why Register?
|
Similar Topics
| Topic | Last Poster | Forum | Replies | Posted |
|---|---|---|---|---|
| Pitch rods lenght increasing?? | Eagle5 | ESKY HoneyBee CP2 (Collective Pitch) | 0 | Fri Aug 29, 2008 7:08 am  |
| Getting the balance right - question | gehall63 | HoneyBee King (Collective Pitch) | 2 | Thu Aug 28, 2008 8:22 pm |
| Another 401 Question | Steve Evans | Trex 450 XL and SE. Electronics, radios, set up, resources and discussion. | 9 | Wed Aug 27, 2008 11:12 pm |
| Swash Mix settings and DX6i | TheMadhatter | Copter-X Helicopters | 2 | Tue Aug 26, 2008 11:18 pm |
| Pitch Range | Steel_City_Blade | Belt CP | 8 | Tue Aug 26, 2008 10:02 pm |
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
