Heliguy Forum - RC heli forum

Hi all ,

I am really in need of some help from anyone who can offer .

I bought a Walkera 1#B & all was good flying OK , (sort of) . After a few days of course i ended up crashing the darn thing, Just softly though , The blades hit the grass & knocked over the heli.


Now at a quick glance i thought it was just the blades,
However checking on it in side i noticed the main Shaft had bent & put a big wobble in it .


So as i went to change the main blades, I noticed that the Flypaddles were a bit of to, I then straightened it out & again i noticed something else which is the biggest thing i can not fix.


The Flypaddle shaft (FLYBAR) is not supposed to move, However for some reason it is sliding Horizontly Left & right , No matter what i try & do, I tighten up the little screws that should hold them in place so the shaft does not move but nothing happens, These little balls screws just keep spinning .


I then thought stuff it, I will buy a new Upgrade aluminium head kit for it as well as a new flybar paddle shaft .

Now i have tried running the flybar through the little metal holder thingy in the new head, Then tightning up those screws to see if they will also hold the flybar still so it dosn't move .

There is some little grooves in the flybar which i try to line up as well, But no matter which way i try i can not get it so the fly bar will stay in 1 spot .


I really do hope someone has some info or something on this as i am stuck between a rock & a hard place & it is giving me the SH@#TS .

I will be waiting here until someone can help



PLEASE

Thanks