I dont consider myself a noob with this anymore but obviously not a pro either but i cannot figure out why i cannot track my blades.
First of all i spin it up holding it in my hand and all is fine untill i get to about speed where it starts to pull up and the blades loose tracking by like an inch all of a sudden, i have new blades, balanced, new straight main shaft, new straight feathering shaft, new straight evenly spaced flybar, swash is level and see saw arms or whatever they are called, all new servos set at 90degrees, blades leveled to 0 degrees middle stick in idle up with pitch tool and tracked, untill about mid stick then splits an inch again. Lost, annoyed and keen to get this thing in the air again, or in the bin...
_________________
HBK2
All Alloy Upgrades
4200kv Brushless
