Help -
I've never had the courage to take it off the ground. Previously had no issues with spinning up the rotors, but this now happens :
All Servos seem to "twitch".
Have I broken something?
The Servos still "twitch" even when I disconnect the plastic bars to the rotor assembly.
The Servo controlling the rear tail blade doesnt always center the blades once the remote is in the central position. Once disconnected the tail will freely go from left to right.
Any help would be much appreciated.
I have a lipo battery
speed cont is wk-wst-30a
new avcs ? with red led marked as PL1102-17. both switches set to nor
Switch settings on remote - WK-0701
1 - ELEV - ON
2 - AILE - ON
3 - THRO - ON
4 - RUDD - ON
5 - GEAR - OFF
6 - PIT - OFF
7 - ON RUDD MIX
8 - NOR/CCPM - ON
9 - CCPN ELEV - ON
10 - PIT LOCK - OFF
11 - TH-CRV/EXP OFF
12 - GYRO SENS/RUDD MIX - OFF
Once powered up, I can hear something sticking. I used to hear a startup "beep", but that doesnt happen. I presume its not reporting as "Ready" due to whatever the problem is.
Please, Please help.
Help - NewBe with twitching problem. Main rotors wont spin
| Author | Message | ||||
|---|---|---|---|---|---|
|
nembsbe New Pilot  Joined: 03 Aug 2008 Posts: 6 |
|
||||
| Profile Private Message | |||||
| Board Alert | Board Message |
|---|---|
|
There are 15 posts in this topic to view if you are logged in.Why Register?
|
Similar Topics
| Topic | Last Poster | Forum | Replies | Posted |
|---|---|---|---|---|
| question about pinion and main shaft | c5 | Belt CP | 1 | Fri Aug 29, 2008 6:42 pm  |
| Honey Bee CP2 Flight Sim Problem | Earlgrey | Flight Simulators Q&A's | 3 | Thu Aug 28, 2008 7:50 pm |
| main shaft gear | Starbuckin | Lama | 1 | Thu Aug 28, 2008 6:50 pm |
| honey bee king 2 pusd rod problem | jatt83 | Other Esky's | 2 | Wed Aug 27, 2008 5:35 pm |
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
