belt cp gyro + servo setup

Post new topic Post reply

Author Message
o0dekker0o
Senior Pilot





Joined: 20 Feb 2007
Posts: 233
Post Posted: Fri Aug 08, 2008 1:10 am
Post subject: belt cp gyro + servo setup 		Quote 
I changed my servos on the Belt CP, is this the correct way to set up the tail, ?


plug the tail servo and bypass the gyro, put the horn on 90 degrees (or close enough) to the boom, then attach servo via gyro and then set up the servo position on the boom by sliding it to get the right spot


If i don;t do this i don't know where the centre is of the servo in head lock mode (telebee gyro)

- trim is in the middle
Back to top Profile Private Message
Display posts from previous:  
Board Alert Board Message
There are 2 posts in this topic to view if you are logged in.

Why Register?

  • Your details are kept secure and private.
  • Heliguy.com will not share your details
  • You can unsubscribe at any time
PM Earlgrey for any forum queries.

Login here and be redirected to this Topic Register

Similar Topics

Topic Last Poster Forum Replies Posted
cp belt gyro kianhon Belt CP 2 Sun Sep 07, 2008 2:04 am View latest post
Gyro Synchronising dondecap Belt CP 1 Sat Sep 06, 2008 11:04 pm View latest post
receiver antenna belt cp tobu Belt CP 6 Sat Sep 06, 2008 6:50 pm View latest post
cp belt power cut Friskle Batteries. 3 Sat Sep 06, 2008 2:06 pm View latest post
Jump to:  

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

heliguy illustration