I changed my servos on the Belt CP, is this the correct way to set up the tail, ?
plug the tail servo and bypass the gyro, put the horn on 90 degrees (or close enough) to the boom, then attach servo via gyro and then set up the servo position on the boom by sliding it to get the right spot
If i don;t do this i don't know where the centre is of the servo in head lock mode (telebee gyro)
- trim is in the middle
belt cp gyro + servo setup
| Author | Message | ||||
|---|---|---|---|---|---|
|
o0dekker0o Flight Commander  Joined: 20 Feb 2007 Posts: 266 |
|
||||
| Profile Private Message | |||||
| Board Alert | Board Message |
|---|---|
|
There are 2 posts in this topic to view if you are logged in.Why Register?
|
Similar Topics
| Topic | Last Poster | Forum | Replies | Posted |
|---|---|---|---|---|
| 0704a HH gyro setup? | redhead1331 | HoneyBee King (Collective Pitch) | 0 | Wed Dec 03, 2008 12:13 am  |
| Belt CP spin counter clockwise | bnflyn | Belt CP | 9 | Tue Dec 02, 2008 9:34 pm |
| servo mounting screws | starik | Copter-X Helicopters | 1 | Tue Dec 02, 2008 8:07 pm |
| Colco GY400 setup?? | glenwyatt | HoneyBee King (Collective Pitch) | 9 | Tue Dec 02, 2008 2:58 pm |
| servo horn length | liamduck0307 | Trex 500, resources and discussion | 2 | Tue Dec 02, 2008 2:14 pm |
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
