There are heaps of clone Align head & tail CNC kits on ebay usually with the words "Main +TAIL UPGRADE KIT For T-rex Trex 450 XL ALIGN 450S". Has anyone had any experiences with these? Most look very much like copter x parts. It's very temping to get a kit just for spares, even if some of the parts are not so good eg bearings/shafts etc. There is one worded " Main CNC Rotor Head & Tail Trex 450 XL SE Align + Bar" which has a swash that appears serviceable as it has 4 screws below. What do you guys think?
_________________
CX 450SE V2
Align 430L motor & 35A ESC
2100T Gyro, HPS18100 tail servo
DX6i/AR6200
SG90 swash servos
Honeybee King II Full Bling (just sold)
Walkera 4#3B (nose in trainer)
"The trouble with Common Sense, is that it isn't very Common"
Align clone replacement CNC parts
| Author | Message | ||||
|---|---|---|---|---|---|
|
fg1972 Flight Commander   Age: 36 Joined: 18 Aug 2007 Posts: 538 Country of choice:  Location: Melbourne, Australia |
|
||||
| Profile Private Message | |||||
| Board Alert | Board Message |
|---|---|
|
There are 6 posts in this topic to view if you are logged in.Why Register?
|
Similar Topics
| Topic | Last Poster | Forum | Replies | Posted |
|---|---|---|---|---|
| im selling my belt cp/copterx/align h... | traxevc | Special Requests | 0 | Sun Nov 30, 2008 9:26 am  |
| Belt-Cp parts, GY401, Futaba S3114 | kianhon | Special Requests | 0 | Sun Nov 30, 2008 8:04 am |
| ESKY KING 2 PARTS & EXTREME UPGRA... | Tamiya10 | HoneyBee King (Collective Pitch) | 0 | Sat Nov 29, 2008 3:32 pm |
| ESKY KING 2 FOR PARTS & EXTREME U... | Tamiya10 | Special Requests | 0 | Sat Nov 29, 2008 3:26 pm |
| Will all Align parts fit? | PokeDad | Copter-X Helicopters | 4 | Tue Nov 25, 2008 2:51 pm |
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
