I need to replace the tail shaft and I cant get it out!
I cant get the end off where the blades mount so I disassembled the tail box and I cant get the pulley off either.
Please Help!
PS, The reason I need to replace this shaft is because it was binding and I thought it was the slider to the shaft, so I filled it down.
This didn't fix the problem so I lubed it and WALA, it slides smooth.
Now it binds because the slider has to much clearance on the shaft and causing it to twist a little and bind.
Thanks
Kevin.
Tail Shaft
| Author | Message | ||||
|---|---|---|---|---|---|
|
chachi New Pilot  Joined: 10 Sep 2008 Posts: 2 |
|
||||
| Profile Private Message | |||||
| Board Alert | Board Message |
|---|---|
|
There are 3 posts in this topic to view if you are logged in.Why Register?
|
Similar Topics
| Topic | Last Poster | Forum | Replies | Posted |
|---|---|---|---|---|
| Tail Rotor Crash - Move Tail Boom | m1byo | Raptor RC Helicopters | 0 | Mon Dec 01, 2008 11:59 am  |
| tail rotor | concorde216 | HoneyBee (Fixed Pitch) | 2 | Sun Nov 30, 2008 10:07 am |
| Tail servo not accurate after Head Lo... | Gav.S | Belt CP | 10 | Sun Nov 30, 2008 7:07 am |
| creeping tail servo HELP | martia | Trex 450 XL and SE. Electronics, radios, set up, resources and discussion. | 6 | Sat Nov 29, 2008 6:52 pm |
| tail motor wire | cyclopops | Walkera 4#3 | 4 | Sat Nov 29, 2008 5:13 pm |
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
