Hi everybody,
I just got my esky lama 2.4ghz just a week ago and have only done a few flights, when one day I noticed that my 2.4ghz transmitter is not sending anymore signal to the receiver. I also noticed that the signal light that blinks as you turn on the transmitter doesn't blink anymore but instead goes solid red right away. I did try to unbind and rebind as per manual instruction but unfortunately nothing happens until I borrowed my friends same esky 2.4 ghz 4 channel transmitter and try it on my lama. To my surprise it works so well. So I can conclude that it is the transmitter failure.
Can anybody give their precious advise on this problem?
esky lama 2.4ghz transmitter problem
| Author | Message | ||||
|---|---|---|---|---|---|
|
airmagnate New Pilot  Joined: 22 Jun 2007 Posts: 4 |
|
||||
| Profile Private Message | |||||
| Board Alert | Board Message |
|---|---|
|
There are 3 posts in this topic to view if you are logged in.Why Register?
|
Similar Topics
| Topic | Last Poster | Forum | Replies | Posted |
|---|---|---|---|---|
| Problem installing drive belt | blinky | Belt CP | 2 | Mon Dec 01, 2008 1:54 pm  |
| Esky Belt CP Standard Gyro Indicator | st200ol | Gyros | 1 | Mon Dec 01, 2008 1:02 pm |
| Lama V4 goes forward - and to the left | Dusty1000 | Lama | 3 | Sun Nov 30, 2008 2:12 pm |
| ESKY KING 2 PARTS & EXTREME UPGRA... | Tamiya10 | HoneyBee King (Collective Pitch) | 0 | Sat Nov 29, 2008 3:32 pm |
| ESKY KING 2 FOR PARTS & EXTREME U... | Tamiya10 | Special Requests | 0 | Sat Nov 29, 2008 3:26 pm |
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
