I have two models set up on my Dx6i, both are flying fine, however, I only added the second heli (King 2) recently and I've noticed that I have to flick the gear switch down to position 1 to engage the HH gyro, whereas when I fly the Trex 450 the gear switch is in the upper position (0) to engage the HH gyro!
Is there a setting that I'm missing here? I'd obviously prefer that HH gyro mode was on the same position for both heli's ie position "0"
Any help much appreciated!
_________________
Simon.
TREX 450 seV2:
430XL outrunner
Futaba GY401 gyro / S9650 tail servo
Hi-Tec HS-65MG cyclic servos
Align 325 Pro blades
HRpolyX alarm
DX6i & AR6100e
Reversed settings DX6i (HH gyro)
| Author | Message | ||||
|---|---|---|---|---|---|
|
asomaro Senior Pilot   Age: 51 Joined: 02 Sep 2008 Posts: 103 Country of choice:  Location: Dorset |
|
||||
| Profile Private Message | |||||
| Board Alert | Board Message |
|---|---|
|
There are 5 posts in this topic to view if you are logged in.Why Register?
|
Similar Topics
| Topic | Last Poster | Forum | Replies | Posted |
|---|---|---|---|---|
| gyro light flashing | willburrrr2003 | Belt CP | 2 | Mon Dec 01, 2008 3:46 pm  |
| Esky Belt CP Standard Gyro Indicator | st200ol | Gyros | 1 | Mon Dec 01, 2008 1:02 pm |
| Gyro Problems | vk6tkr | HoneyBee King (Collective Pitch) | 2 | Mon Dec 01, 2008 2:35 am |
| Tail servo not accurate after Head Lo... | Gav.S | Belt CP | 10 | Sun Nov 30, 2008 7:07 am |
| Auto trim e Gyro Mode | Trooper | Helicommand General | 1 | Sat Nov 29, 2008 10:05 pm |
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
