After taing advice form here i went for the Belt-Cp, it arrived yesterday. I opened the box and all is fine, i had a good look over the helicopter and have some questions!
So where do i start, i have read the above guides which are helpfull but they dont have enough info about what to do straight out of the box.
The main blades are folded up, so do i manually fold out and they click into place? then i tighten the screws to hold in place?
The tail rotor blades and angled, again do i straighten these or do they manually straighten when they rotate?
Do i have to tighten all the screws, nuts & bolts up?
These are the main items of concern at the moment, once these are sorted i can go ahead with the above guides and align all the gubbins.
Where to start with Belt-CP?
| Author | Message | ||||
|---|---|---|---|---|---|
|
dave1978 New Pilot   Joined: 14 May 2008 Posts: 27 Country of choice:  Location: Cheshire |
|
||||
| Profile Private Message | |||||
| Board Alert | Board Message |
|---|---|
|
There are 9 posts in this topic to view if you are logged in.Why Register?
|
Similar Topics
| Topic | Last Poster | Forum | Replies | Posted |
|---|---|---|---|---|
| E Sky Belt CP | Edhayd | Belt CP | 3 | Fri Aug 08, 2008 5:12 pm  |
| scale fuselage question for belt CP | Friskle | Belt CP | 4 | Fri Aug 08, 2008 3:13 am |
| belt cp gyro + servo setup | c5 | Servo's | 1 | Fri Aug 08, 2008 1:10 am |
| futaba tx & belt cp - what xtals ... | ccsteehee | Belt CP | 3 | Fri Aug 08, 2008 12:23 am |
| EFlite Replacement For Belt CP Tail S... | jonnyb | Belt CP | 1 | Thu Aug 07, 2008 11:48 pm |
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
