Boscam Galaxy D2 FPV Monitor Review

The New Galaxy D2 FPV Monitor From Boscam.

Boscam galaxy d2

This monitor has a foldable sunshade that also acts as a screen protector when not in use. The unit itself also looks very clean and well designed.



What’s in the box of the Boscam Galaxy

Boscam galaxy d2

There is a charger included separately. It also comes with deans connector if you’d like to run it from an external battery, a mounting bracket for radio receivers and a AV lead fir inputting and outputting audio and video.

It also comes with mounting plate for tripod stand

Boscam galaxy d2

On-off switch, and the mini-dip switches to select the channels on R1 and R2. Diversity is selected by choosing the same channel on both sides.

Boscam galaxy d2

It has 3 video outputs 1 for each receiver and 1 that automatically selects the best one for output. There is also a video input

Boscam galaxy d2

There is only one switch to switch between R1 and R2’s channel when not in diversity mode.
Charging led (red = charging, green = charged): the initial charge took about 4-5 hours to full on my 1.5A 12v charger.

Large bright screen
Well built, high quality plastic
Clean design, not many switches/buttons to fiddle with
Built in 4000mah lipo (presumably) with good battery life
foldable sunshade which acts as screen protector when not in use
Mounting clip for radio receiver well thought and very sturdy

Charging took quite long to full charge
Does not have OSD to change screen settings – contrast, brightness etc etc
Default contrast is too high – “burns out” highlight areas and reduced the amount of detail

Boscam galaxy d2The high contrast makes it a little hard to see on a bright days light due to the clipping washing out alot of the detail.

Boscam Galaxy D2 Specs
Screen: 7” TFT LCD screen, LED backlight
LCD panel resolution: 800×480
TV lines: 400TVL (a DVD is 500TVL so 400 is ok)
Brightness: 400 cd/m²
Contrast: 500:1
View Angle: 140/120 degree (Horizontal/Vertical)
Antenna Connector: RP-SMA
Channel: 5.8G Input; 4 Brands/ 32 Frequency selectable
Size: 176x112x24mm (Height of light shield:102mm)
Battery: Built-in 4000mA Li-Po battery
DC: 12V/1A
Power Consumption: 600mA at 12V(maximum)

Advanced Specs
Spatial resolution: 450×380
Active deinterlacing: none
Deinterlacing method: Blend
3D noise reduction: none

Comments are closed here.